Autotether Wireless Lanyard Standard System El manual del propietario descargar pdf (Pagina 16)

3.) Apply pressure to compression tool to push tabs in, at the same time

apply pressure to wedge tool. The clip will release.

4.) Remove clip.

OPTIONAL:

The loop on the actuator case is used to attach your existing red

lanyard. This can provide an extra measure of security should you decide

to use it this way.

To use it:

1.) Attach the spring clip (provided) to the end of the red lanyard then

place the spring clip onto the loop.

2.) Attach the other end of the lanyard to your belt or other adequate

item on your body.

Wedge

Pushers

Seam

Tabs

Loop

Spring clip

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

Sin comentarios

Autotether Wireless Lanyard Standard System El manual del propietario Pagina 16